This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| manual_mcf-lwws0x [2025/02/28 12:30] – [12 Declaration of conformity] supportadmin | manual_mcf-lwws0x [2025/09/08 15:03] (current) – [2.1 Technical data] sensors | ||
|---|---|---|---|
| Line 54: | Line 54: | ||
| Based on the different version, some sensors can be not present. | Based on the different version, some sensors can be not present. | ||
| - | ==== 2.1 Technical data ==== | + | ==== 2.1 Technical data ==== |
| * CPU Cortex M0+ | * CPU Cortex M0+ | ||
| Line 75: | Line 75: | ||
| * 5W Solar panel powered with 6V12Ah battery | * 5W Solar panel powered with 6V12Ah battery | ||
| * Mounting Tripod with Lag Bolts | * Mounting Tripod with Lag Bolts | ||
| + | * Estimated Battery Run Time (fully charged, in darkness): over 60 days. | ||
| + | Power consumption of the LoRaWAN interface (with no PM sensor): \\ - floor current: 500uA; \\ - 600mW for a duration of 2 seconds for every LoRaWAN transmission (worst case); \\ - 800uA as average with 1 message every 15 minutes, SF = 12; \\ - PM sensor additional average consumption: | ||
| - | Power consumption of the LoRaWAN interface (with no PM sensor): | + | === 2.1.1 Davis Instruments detailed data === |
| - | - floor current: 500uA;\\ | + | |
| - | - 600mW for a duration of 2 seconds for every LoRaWAN transmission (worst case);\\ | + | |
| - | - 800uA as average with 1 message every 15 minutes, SF = 12;\\ | + | |
| - | - PM sensor additional average consumption: | + | |
| - | === 2.1.1 Davis Instruments detailed data === | + | ^Version |
| - | + | ||
| - | ^Version ^Davis Code ^Description | + | |
| |MCF-LWWS00/ | |MCF-LWWS00/ | ||
| |MCF-LWWS02/ | |MCF-LWWS02/ | ||
| Line 123: | Line 119: | ||
| - Fasten the 6316CEU to the box | - Fasten the 6316CEU to the box | ||
| - Connect the red wire terminal “B” to the positive terminal of the battery “C”. | - Connect the red wire terminal “B” to the positive terminal of the battery “C”. | ||
| - | - Connect the white connector | + | - Connect the white connectors |
| {{ : | {{ : | ||
| - | {{ : | + | {{ : |
| Power can also be supplied by USB, //**only for configuration, | Power can also be supplied by USB, //**only for configuration, | ||